MANCAN Tool installation to the CAN line parking sensor (only for Alfa Romeo 159).

If there is a wiring for factory parking sensors in your car, then find the connectors in the sketch and connect the device according to the wiring described below.

You need to have a constant 12V that does not interrupt during start-up and access to the B-CAN line.

• CAN-A = B-CAN-L (Low) / BS – White cable with pink stripe to the GREEN cable of the module

• CAN-B = B-CAN-H (High) / NS – Black cable with pink stripe to the RED cable of the module

MANCAN Tool installation to optional CAN line (only for Alfa Romeo 159).

Following the sketch, you can install the MANCAN Tool to any of the CAN lines shown.

In-car modules (nodes) connected to the Body Computer M1 via B-CAN:

CAN-A = B-CAN-L (Low) / BS – White cable with pink stripe to the GREEN cable of the module

CAN-B = B-CAN-H (High) / NS – Black cable with pink stripe to the RED cable of the module

• underfacia junction unit B2 ;
• instrument panel E50;
• driver“s side door control unit M66 ,
• passenger side door M67 ;
• boot compartment control unit M63 ;
• parking sensor control unit M84 ;
• seat control unit H66 and H67;
• Air Bag control unit M60 .
• climate control sytem control unit M70;
• controls on the steering wheel (via the clock spring D47);
• built-in radio-telephone-navigator P20;
• Bluetooth control unit M162– steering lock control unit M89 ;
• TEG Reader H3.